Dim system status lights on dsc alarm panel

DIM SYSTEM STATUS LIGHTS ON DSC ALARM PANEL TV

DIM SYSTEM STATUS LIGHTS ON DSC ALARM PANEL TV

Your home should already have a VERY thick wire that is clamped to this ground connection and run to the electrical box.ДЄlso, any coaxial cables for cable TV or satellite will also be grounded right as they enter the home and you can either leverage that ground or trace it back to the grounding clamp.ДЇinding a good ground is another good reason to locate the alarm panel with other wires in a basement or utility closet. There is no need to figure this out for yourself. Tapping the building's main ground normally means clamping a wire to the copper water pipe as a ground or connecting it to a driven ground rod. This is easy for me because my wiring panel (which is only a couple of feet from the electrical box) already has a direct ground connection for other wiring. I prefer to tap directly into the building's main ground. You could run the ground from the ground connector on the power supplyДЄnd it will work since this ground will run back to the electrical box and then to the building's main ground. To differentiate the positive and negative wires.ДЇor this alarm, the ground is located at the opposite end of the circuit board. Usually your power wire will be colored, labeled with + or -, or will have a stripe (for power) Connect the + terminals together and the - terminals together.

Typically, both the power supply and alarm panel will have power connections The power supply will either have 2 screw terminals (+, -) or 3 terminals (+, -, ground). Using 18 AWG or better wire, measure the length of wire needed to connect the power supply at the power outlet to the power terminals on the circuit board.ДЇirst connect the wires to the power supply, then the wires to the alarm panel, and then finally plug in the power supply to the electrical outlet. Connect the ground first (black), and then the power (red). The wire colors will be red & black which match perfectly the red and black terminals on the battery itself. Buying the recommended BD7-12 battery or purchasing the battery, power supply, and main board in a kit is easier. In this case, they should both be 12 volt 7 amp-hours. First, verify that the power requirements of the circuit board match those of the battery. For this alarm system, the wires for the battery come directly out of the side of circuit board.

Dim system status lights on dsc alarm panel